This article will address how to Repair Electric Fireplace Squeaks on a Napoleon EF-30B Electric Fireplace.
When we started looking at RVs a few years ago we came across a lot of the higher-end 5th Wheels and Motorhomes that had electric fireplaces in them. We thought to ourselves, why would we want a fireplace in our RV? It wasn’t something on our list of must-haves or even something we wanted. Of course, the motorhome we finally went with had one, and boy are we glad it does when it was all said and done.
Our 2019 Thor Challenger 37YT came with a Napoleon EF-30B Electric Fireplace. The first month on the road we discovered that the electric fireplace actually did a pretty good job keeping the motorhome warm, at least the front half. We discovered this after not utilizing the fireplace to its full potential and relying more on the propane furnace to heat the motorhome.
By not utilizing the full potential of the fireplace we burned through our propane supply quickly in the cold climate at our stop in Aurora, Colorado. After talking to some fellow RVers, we started using the electric fireplace and bought a small ceramic heater for the bedroom greatly reducing our propane usage.
This post contains affiliate links. As a participant in Amazon Associates and various affiliate programs, we are compensated when qualifying purchases are made through our referral links at no additional cost to you. Full Disclosure
We do all our trip planning with RVTrip Wizard. RV Trip Planning Made Simple! RV Trip Wizard is by far the best RV route planner we’ve found. Get your 7 day Free Trial
The Squeak!
In February 2020 a small squeak started coming from the fireplace. It wasn’t too bad to start with and would come and go. Do you know how constant noise can really drive you crazy? A month later the squeak was back and this time it was not going away… It constantly squealed and seemed to eat at my soul.
I started looking for the culprit and finally stumbled across some information that said the squeak comes from the fire effect mechanism. What is the fire effect mechanism? The fire you see on the front of the electric fireplace is created by refracting light from LED bulbs in random 3D patterns to a screen.
The mechanism is just an electric motor with a rod lined with shiny plastic pieces that reflect the light onto the screen. One end of the rod is attached to a small electric motor the other end goes through a grommet in the mounting hole. This is where the squeak comes from.
Getting rid of the squeak
The squeak finally got to a point it was constant, loud, and annoying! It had to go! Not being able to run the fireplace because the sound could be heard over the TV we shut it down and had to run the furnace for a night. The next morning I got up and started working on getting rid of the squeak.
We’re putting this item on our bi-annual maintenance list. Not only lubrication of the fire effect motor and rod but also cleaning the heater fan.
- Maintenance Schedule: Bi-annually
- Difficulty: Very easy, you can do this yourself with minimal tools and mechanical experience.
- Time to complete maintenance: Give yourself about an hour to complete. It is really a simple process and could be done between 30-60 minutes.
- Tools and Supplies Required: #2 Phillips Screwdriver, Canned Compressed Air, Rags or Wipes, WD-40 Lithium Grease, or similar lubricant.
STEPS TO COMPLETE:
- Turn off the fireplace and ensure it has cooled before starting the repair.
- Remove the fireplace shroud to gain access to the mounting screws. The fireplace shroud just slides up and pulls off.
- Using a #2 Phillips screwdriver remove four mounting screws from the edges of the fireplace.
- Pull the fireplace slightly out from its location.
- Unplug the fireplace from the outlet and remove the fireplace to a location to complete the repair.
- Clean the fireplace exterior with damp rags or wipes to remove dust.
- From the backside of the fireplace remove the 10 screws along the edge of the back panel. Lay the back panel down. (Be careful not to pull the back cover directly away from the fireplace. There are wires connecting the fire effect motor attached to the back panel.) At this point, you have access to the fire effect motor and rod that is causing the squeak.
- Clean the area removing any dust and debris from the area.
- Lubricate the motor shaft and rod end at the grommet with WD-40 Lithium Grease or similar lubricant. This is where the squeak comes from.
- If you only had the squeak to get rid of you can put the fireplace back together at this point by following the steps in reverse order. Or if you would like to clean the Heater Fan also while you have the fireplace out, continue onto the next steps.
- To remove the top panel remove the six screws along the top edge three on each side.
- Remove the top panel.
- You now have access to the heater fan electrical panel and controller.
- Blow the heater fan out with canned compressed air.
- Wipe fan blades and surrounding area clean.
- Put the fireplace back together by following the steps in reverse order.
Replacement
About 9 months after I initially wrote this article the blower motor on our fireplace went out. I tried getting a replacement blower to swap out but found that the manufacturer of our motorhome had listed the fireplace as a much larger home fireplace.
When I got the blower motor it was at least three times too big to work in our fireplace. So upon further review, I found it cheaper to replace the whole fireplace. Come to find out our exact fireplace is the RV Titan Flame Model EF-30B 26″ Curved LED Insert Electric Fireplace. I found the replacement on Amazon. Your fireplace may be larger or smaller depending on your RV.
RV Titan Flame Model EF-30B 26″ Curved LED Insert Electric Fireplace
The replacement fireplace has worked much better than the original one put in by Thor. This one heats well and has not had the squeak in the two-plus years we’ve had it.
Conclusion
When your electric fireplace has a noisy squeak or is in need of a good cleaning don’t be afraid to jump in and get it done yourself. It’s a simple job that’s not too difficult and doesn’t take much time. Cleaning and maintenance on your electric fireplace is something the dealers should let us all know about when we buy an RV but of course, they don’t.
We’re finding more and more things that we wish we knew or were told about when we bought our motorhome. Almost all of them are fairly easy maintenance items that will keep your RV in tip-top shape for many years of enjoyment.
What maintenance items have you run into that you wish you knew when you first started RVing?
Thank you for reading our article. If you have any comments or questions we’d love to hear from you below.
If you’re looking to build your own home-based business like we have with this webpage, check out Wealthy Affiliate.
Wealthy Affiliate is an all-in-one platform that you can build your whole affiliate marketing business on. It combines training, software, and website hosting into one. This makes the whole process of starting an online business from scratch much easier, especially if you’re new to building a website.
Your fireplace fix/problem was similar to mine.
In my case, it was an intermittent thumping noise.
I knew it had to be something like your problem because it did it even when the heat was not on, just the fake flames.
My unit was a practically new MASTERFLAME TED25 G3 home unit in a large TV cabinet.
Manual here. https://www.manualslib.com/download/1222143/Masterflame-Ted25-G3.html
So after I moved the cabinet out from the wall and removed the bottom of the case (where the offending part was), I plugged it back in and turned it on, and I could see after almost every rotation, that the plastic spinner rod was not quite true or straight and the 1/8″ rod was rotating inside a 1/4″ opening grommet and sort of jumping in the large grommet hole as it rotated making the thumping noise.
I just happened to have a case of assorted sized grommets that I bought on sale at Canadian Tire a while ago, so I swapped out the grommet for one with a much smaller hole and greased the whole thing. Problem solved.
Hope this helps someone.
Thank you for your input, Rick. The issue with your fireplace was definitely different than mine. Good to have the info on other issues that may pop up on these fireplaces. The fireplaces do a fairly good job for what they are. They do require some upkeep and maintenance on them to keep them in working order. Thanks again for your comments and help.
Rob