SnapPads Installation and Review: Are They Worth It?

When we hit the road full-time in 2019 with our Class A motorhome, we were RV rookies. The parts department at Giant RV helped us grab the basics—but didn’t mention anything about jack pads or SnapPads. It wasn’t until our eighth stop that we realized how important they were, especially when camping on soft or unlevel ground.

Here’s our full SnapPads journey—from the first installation fail to the final success—and why we think they’re a must-have for every RVer.

This post contains affiliate links. As a participant in Amazon Associates and various affiliate programs, we are compensated when qualifying purchases are made through our referral links at no additional cost to you. Full Disclosure

Our First Encounter with Unlevel Sites

We cruised through seven campgrounds with no leveling issues. Most sites were flat, paved, and easy to set up on. Then came Bear Cave RV Campground in Buchanan, Michigan—a lovely Thousand Trails park, but not every site is level.

Our assigned site was soft dirt, and when we dropped our hydraulic jacks, the front tires came off the ground 6–8 inches. Worse yet, the jacks sank slightly into the soil.

We quickly learned: we needed jack pads—and fast.

The Search for Jack Pads in RV Country

We figured finding jack pads in Elkhart, Indiana—the RV capital of the world—would be a breeze. Not so much. Most places just build RVs. Finding a local dealer with accessories was harder than expected.

We finally scored a set of overpriced Camco FasTen 2×2 Jack Pads at our third stop. They worked okay but barely covered what we needed. We later added more Camco blocks and even tried Anderson Jack Blocks, but those didn’t work well with our motorhome’s jack clearance.

What Are SnapPads?

If you’re not familiar, SnapPads are permanent rubber jack pads made from recycled tires. They install directly onto your motorhome’s leveling system and provide:

• A larger, more stable footprint
• Shock absorption and vibration dampening
• A solid grip on uneven or slick surfaces like gravel or ice

No more crawling under the RV with wood or plastic blocks. Once installed, you’re done for good.

Affiliate Tip: Want to know which SnapPads fit your RV?
👉 Use this SnapPad fit guide and then come back to support us by shopping through the links below!

Before SnapPads: What We Tried (and What Didn’t Work)

After that first encounter with a soft, unlevel campsite, we realized we needed more than just one set of jack pads. While the overpriced Camco FasTen 2×2 Jack Pads we grabbed in Elkhart got us by, they weren’t ideal—and certainly not a long-term solution.

What We Bought Next

• A second set of Camco FasTen 2×2 Pads
• One set of Camco FasTen 4×2 Pads
• Purchased both from Amazon at far better prices than the dealer charged

These Camco pads came in handy—especially for stacking under tires when the site was really off-level. In fact, we often still use all 30 pads at once to get our coach leveled correctly.

We also picked up a set of Anderson Jack Blocks. Giant RV had shown them to us when we bought our rig, but they seemed a bit pricey at the time. Eventually, we gave them a shot.

Why the Anderson Blocks Didn’t Work for Us

Although the concept is solid, they were just too tall to fit under our jacks most of the time. That made them impractical for everyday use with our particular setup.

And that’s when we started researching better, more permanent solutions—and found SnapPads.

Recommended SnapPads by Jack Type

Here are some of the most popular SnapPad sets. Make sure you choose the one that fits your RV’s leveling system:

For Lippert Leveling Systems with 9” round feet: (These are the feet on our’s and many Class A motorhomes.)
👉SnapPad XTRA 9″ (4-Pack)

For Bigfoot Landing Feet:
👉SnapPad BF (7″ 4-Pack)

For Equalizer Systems (Round Feet):
👉SnapPad EQ (4-Pack)

For HWH Systems (8” Front / 10” Rear):
👉SnapPad HiWay Plus (4-Pack)

For 5.5” Tongue Jacks / Stabilizers:
👉SnapPad Mini (4-Pack)

For Equalizer Systems with 10” round feet
👉 SnapPad EQ 10″ (4-Pack)

Our First Attempt (and Failure) Installing SnapPads

Excited to simplify our setup, we ordered the SnapPad XTRA model for our Thor Challenger’s 9″ Lippert jack feet. They arrived quickly, and we followed the included instructions.

Unfortunately… no “snap.”

Two pads stayed on the ground when we lifted the jacks. The other two stayed on the jacks but could be knocked off by hand. We tried multiple times with no luck.

Great Customer Service Saves the Day

I reached out to SnapPad’s customer support, and within hours, they asked for pictures of our jack feet. They immediately identified the issue: our Lippert feet had warped, a known issue on some newer models. The deformation made them smaller than 9”, causing the SnapPads to fall off.

Replacing the Jack Feet

We used our Camco pads for another year until we finally had time to order replacement jack feet—an additional $140 expense we could have avoided.

Once our Workamping gig wrapped up, I was ready to try again.

Second Attempt: Success!

At our campground in Las Vegas, I installed the new feet using a 15/16” socket and my battery-powered impact wrench. Once done, the SnapPads went on in minutes—just like they’re supposed to.

Each one snapped on perfectly in about 3–4 minutes.

SnapPad Installation Tips

If you’re installing SnapPads, here’s what worked best for us:

1. Do it on level, hard ground (concrete or asphalt)
2. Chock your wheels before starting
3. Clean and dry the jack feet
4. Use dish soap (not WD-40!) around the SnapPad lip
5. Use walkie-talkies for jack communication
6. Install one at a time, manually if possible

KEEP YOUR FINGERS AND ANY FOREIGN OBJECTS CLEAR WHEN LOWERING THE JACK INTO PLACE.

If the SnapPad doesn’t fully engage, shim the side that didn’t catch with a small piece of wood and try again.

Shop SnapPads Now

Support our travels by shopping through these Amazon affiliate links (it doesn’t cost you a penny extra):

• SnapPad XTRA 9” (for Lippert Systems)
• Browse all SnapPad options on Amazon

Upgrade Your RV with SnapPads

Tired of dragging out wood blocks or plastic pads at every stop? SnapPads are a permanent, American-made leveling solution made from durable recycled rubber. They improve stability, reduce shifting and popping, and protect your jacks from wear and tear.

👉 Get SnapPads on Amazon

Thanks for your support—and happy leveling out there!

Final Thoughts: Are SnapPads Worth It?

Absolutely. We wish we had bought them sooner.

Once installed, our motorhome stopped popping and shifting during setup. It feels far more stable now. Plus, no more messing around with stacks of blocks at every stop.

We were also blown away by SnapPad’s fast and friendly customer service. And yep—they’re American-made, which we love supporting.

💡 Pro Tip: Don’t wait like we did. If your jack feet are in good shape, SnapPads should be the first upgrade you make on your RV.

Thank you for taking the time to read this article. Have you installed SnapPads on your RV? What are your thoughts on them? Let us know below.

If you’re looking to build your own home-based business like we have with this webpage, check out Wealthy Affiliate.

Wealthy Affiliate is an all-in-one platform that you can build your whole affiliate marketing business on. It combines training, software, and website hosting into one. This makes the whole process of starting an online business from scratch much easier, especially if you’re new to building a website.